                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:2059707
iPhone 6+ Stand Remix by bernbout is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

Remix of excellent design that can be printed without supports. Fits my iPhone 6+.

The WIP stand provided by properbowen -  including silicone case model was used. 
- Fixed an error of a small ledge left behind at the back support.
- Socket for charger was not designed to take into account thickness of case at the bottom. Raised by 2mm so the phone + silicone case now clips in.
- Original was designed for Portrait only. Modified so that same stand can be used for both Portrait (charging) and Landscape (watching movies)

Sketchup file included.

# Print Settings

Printer: Geeetech Full Metal Aluminum
Rafts: No
Supports: No
Resolution: 0.2
Infill: 20%

Notes: 
Original design was very well done so no need of supports. Took about 5+ hours @ 40mm/sec and 0.2mm layer height.